MICRESS Forum

Posted: **Fri Oct 21, 2022 2:24 pm**

Dear Bernd,

I have built a 3D model. Why is the geometry not found when I open the file, but the program is running normally? Why is this?

lv

Posted: **Sat Oct 22, 2022 12:37 pm**

Dear lv,

The message means that the .geoF-file has not been written yet. This can be the case if the writing of the t=0 output has not been finished yet. If the 3d-geometry is large, and you are writing over network, this can take a while...

Bernd

MICRESS Forum

3D model

3D model

Re: 3D model